Skip to content
The TRIPLE D E-Xtension

How it works

The E-Xension consists of a high end standard carbon extension provided with a 12V LIPO battery powered Actuator at the inside.

The outside

The TRIPLE D E-Xtension is basically a high end UXT Carbon Extension provided with 3 pulley wheels with extreme low friction.

  • Overall length 610 mm
  • UXT pin connection with the (un) locking button on the side
  • 3 stainless steel pulleys wheels with brass bearings on a stainless steel axes.
  • OD 32 mm, ID 26,2 mm

The E-Xtension can always be used either  with and/or without the remote controlled battery powered geared engine. The UXT base is provided with a 3 pulley system with special exchangeable Teflon/brass bearings that will guarantee the lowest friction (< 0,1) possible for a long duration. Normal friction coefficient between stainless steel axes and stainless pulleys  can go up to > 0,5. The low friction will provide the easiest trim possible and extended battery autonomy during one session. The bearings are exchangeable!

Outside

The inside

The Actuator and battery pack will slide precisely inside the machined inside tubing of the Carbon- Xtension. The topside of the Carbon E-Xtension is provided as a double secured watertight chamber to protect electronics and battery pack against (sea) water up to IP 67 (*). We advise not to disassemble the tubes on the beach or without careful rinsing ! This could harm the waterproof properties.  The actuator is provided with a standard DYNEEMA rope.

Inside

Before use 

The system needs to be activated by a special LIPO switch on top. It is necessary to keep the (red) ON/OFF button carefully gently pressed down at least 3 seconds until the 2 leds ( PWR and LIPO) will light up. In this way the LIPO is protected against undervoltage! The top bracket is provided with 2 rubber rings to seal the top part of the waterproof chamber. Be sure both rings at the top bracket are present and well greased with acid-free petroleum based jelly. The same jelly should be used for the lower rubber ring. Both the top bracket rings and the lower rubber ring provide the waterproof chamber.

Remote controls and electronics 

All E-Xtension are provided with 2 remote controls for attachment on each side of the boom. Preferably the remotes should be attached between the harness lines in such a way that the red leds are mounted in the sailing direction. The remote holders  are each provided with 2 channel controls. The remote system is working on a 433 Mhz frequency. This frequency is an International dedicated frequency for purposes like this. Each remote is however provided with an individual single rolling code. If remotes are lost and new ones are ordered they need to be programmed by the owner. This is possible by pushing the reprogramming button for 3 seconds on the battery pack.

Electronics

The system has the following properties:

  • The electronics are protected against general overheating by a thermo switch (< 70 dgr)
  • It takes about 60 seconds to cool down after overheating due to overpowering.
  • Electronic prints and chips are protected against overheating (< 170 dgr).
  • The system is provided with electronic limit switches at both ends.
  • The electronics have been provided with an “ïndividual” receiver code 433 Mhz.
  • New remote switches need to paired/programmed
  • The system has an internal clock that is set at 12 seconds after activation with the remote

Downhaul is divided in 4 steps for complete downhaul and/or complete release. 

TRIPLE D
E-Xtension

The E-Xtension is delivered with;

  • UXT rdm Carbon extension 610 mm
  • Base with 3 pulleys ultra low friction
  • Geared-engine, battery, carbon support tube
  • Dyneema rope (attached)
  • 2 remote controls with holders
  • Charger (balanced 3s Lipo)

Always the best trim

Back To Top